SETUP & OPERATION
Planning / thicknessing
3
3-4 EGdoc072921
3.2.2 Planning / thicknessing
DANGER! Before you remove any cover of the planer, ensure that the
power is switched off and that the cutter are not rotating.
WARNING! Use protective gloves, particularly when you need to
loosen screws that are tightly fastened, or when you are tightening
screws (see safety instructions).
WARNING! Beware of the planer knives. It is extremely easy to cut
yourself on these, even with the slightest touch.
DANGER! Planing/moulding is possible only in direction shown below.
Arrow “A” indicates planning direction on the upper table. Arrow “B”
indicates planning direction on the lower table. Never try
planing/moulding in the opposite direction.
DANGER! When planing on the upper table use the pusher “C”
provided with the machine. It is not allowed to push the material by
hand!
See figure 3-2.
FIG. 3-2
To Next Page
Loading...
