Setup & Operation
Initial Setup
Setup & Operation SS09doc042913 1-1
1
SECTION 1 SETUP & OPERATION
1.1 Initial Setup
See Figure 1-1. Turn the sawmill control key switch to the ON (#1) position. Simple Set
will start up in manual mode. As the control powers up, the software revision is displayed.
This information can be helpful should you require service.
In manual mode, press the Up arrow to enter the setup menus.
Set Speed: Available values are 1 - 5. The default value is 5. Lowering the Set Speed will
assist in achieving the desired blade height setting in situations where the up/down
chains or mast pads are too loose.
Use the Up and Down buttons to scroll to the desired Set Speed setting.
Press the Auto button to scroll to the Units menu or the Manual button to exit.
Units: Simple Set can display units in inches (default) or millimeters.
Push the Up or Down buttons to scroll to the desired unit setting.
Press the Auto button to scroll to the Language menu or the Manual button to
exit.
FIG. 1-1
3H1041
Scroll
Up/Down
Display
Manual
Auto
To Next Page
Loading...
Need help?
General
