Need help?Do you have a question about the Woodward easYgen-2000 and is the answer not in the manual?
General| Digital Inputs | 8 |
|---|---|
| Digital Outputs | 6 |
| Communication Protocols | Modbus RTU |
| Display | Graphic LCD |
| Protection Degree | IP20 |
| Model | easYgen-2000 Series |
Explains how to operate the unit via the front panel, covering button functions and display meanings.
Details the process of installing and using the Woodward ToolKit software for PC-based configuration.
Describes the multi-level password access hierarchy, allowing different degrees of access to parameters.
Allows configuration of measurement settings, including generator type, frequency, voltage, and current transformer details.
Defines the type of monitoring for generator voltage, choosing between phase-neutral or phase-phase measurement.
Configures two alarm levels for generator overfrequency monitoring with definite time alarms.
Configures two alarm levels for generator undervoltage monitoring with definite time alarms.
Configures two alarm levels for mains underfrequency monitoring with definite time alarms.
Monitors engine start attempts, triggering an alarm if the engine fails to start within configured attempts.
Monitors engine shutdown process, triggering an alarm if the engine fails to stop within the configured time.
Configures circuit breaker monitoring for GCB reclose and open alarms, including related parameters.
Configures synchronization parameters for the GCB, including timeout, alarm class, and self-acknowledgement.
Configures circuit breaker monitoring for MCB reclose and open alarms, including fault and logic settings.
Configures flexible limits for monitoring analog inputs, allowing custom alarm and control settings.
Configures two alarm levels for battery overvoltage monitoring, with definite time alarms and adjustable limits.
Configures breaker settings like application mode, transition modes, and dead bus detection.
Configures input and output settings, including analog inputs, discrete inputs, and relay outputs.
Configures engine settings such as type, start/stop sequences, idle mode, and emergency run parameters.
Configures automatic operation modes, including start/stop logic, load-dependent start/stop, and generator selection.
Configures controller parameters for voltage, frequency, load, and power factor control.
To Next Page