ENGLISH
14
Blind Button
Home Button
Tap Sync Button
Full On Button
Black Out Button
Fade Time Slider
Speed Slider
Audio Level Slider
Fog Machine Button
Hold Button
Step Button
Audio Button
Master Slider A
Master Slider B
21
22
23
24
25
26
27
28
29
30
31
32
33
34
This button is used to maintain curret scene.
This button is used to go to next step when the Speed Slider is
pushed to the button or in Edit mode.
Activates audio sync of chase and audio intensity effects.
This slider controls overall output of all channels.
This slider controls the chase of all programs.
This function takes the channel out of the chase of a program in
CHNS / SCENE mode.
This button is used to deactivate the Blind.
Repeatedly tapping this button establish the chase speed.
This function bring overall output to full intensity.
This button is used to kill all output with exception for that resulting
from Flash and Full On.
Used to adjust the Fade Time.
Used to adjust the chase speed.
The slider controls the sensitivity of the Audio input.
36
35
42
41
40
3938
37
85 mm
REAR
REAR
Power Switch
DC Input
MIDI Thru / Out / In
DMX Out
DMX Polarity Select
Audio Input
Remote Input
Fog Machine Connector
DC 12-20V. 500 mA. mín.
35
36
37
38
40
41
42
This switch turming on or off of the power.
MIDI ports for connection to a sequencer or MIDI device.
This connector sends your DMX value to the DMX fixture or DMX
pack.
Used to select DMX polarity.
Black Out and Full On may be controlled by remote control using
a standard 1 / 4" stereo jack.
This RCA accepts a line level audio input signal ranged from 100mV
to 1Vpp.
39
Finally, we want to remember you that:
- Keep the set far from the humidity and avoid that any kind of liquids fo into it. If
this occurs being the mixer switches on, switch it off immediately from the mains.
- Place the mixer away from excessive heat and from direct sunlight.
- Avoid to accumulate dust, above all in the connectors and in the cooling grilles.
- Prevent that metallics objects enter into the mixer.
- If the mixer or the protecting fuses burn out, replace by ones with the same value.
Under no cirumstance, try repair a fuse.
- If you set up the mixer in a rack, be sure that it disposes of an air renovation grille.