12
2. Depending on temperature and frequency of operation, the
adjustment valve inside the Lubricator may need to be reset. Most
likely the factory setting of FIVE will be correct. If more lubricant
is desired, remove the Fill Plug and using a flat tip screwdriver turn
the valve counter-clockwise to raise the setting and clockwise to
lower. It is not necessary to shut air off to the GO-A8-PW during
this procedure.
3. Check the oil level sight glass daily.
4. For Lubricator replacement parts, See APPENDIX E: Lubricator
Components, pg E-1.
Figure 5: Lubricator
5. For cold weather operation, such as winter conditions (below
40° F), when the GO-A8 is used outdoors or in an un-heated
service area, the Lubricator should be filled with a Winter Grade Air
Tool Oil (PN: 40007).
6. For Food Service applications you must use a high-quality Food
Grade Air Tool Oil. Contact your WORKMASTER Distributor for
Product recommendation.
CHAMBER #2
Lower
AIR IN
OUT TO
GO-A8-PW
CHAMBER #1
(Upper)
Fill Plug
To Next Page
Loading...
