WARNING!
Risk of electric shock!
A faulty electrical installation or excessive mains voltage may result
in an electric shock.
− Only connect the table saw if the mains voltage of the socket
corresponds to the specification on the nameplate.
− Do not kink the mains cord and do not lay it over sharp edges.
− Only connect the table saw to an easily accessible socket so
that you can quickly disconnect the table saw from the power
supply in the event of a fault.
− If an extension cord is required, make sure its diameter is
sufficient to accommodate the power consumption of the saw.
Minimum diameter 1mm
2
.
− Only use cable drums if the cable is completely rolled out.
− Check the mains connection line. Do not use any faulty or
damaged connection lines.
− The table saw is equipped with a safety switch to protect it
against reactivation after a voltage drop.
− Never operate the table saw in wet rooms or in the rain.
− If the mains connection line of this device is damaged, it must
be replaced by the manufacturer, its customer service depart-
ment or a similarly qualified person in order to prevent risks.
− Do not open the housing; instead, have a qualified profession-
al perform the repairs. Contact a qualified workshop for this.
Liability and warranty claims are waived in the event of repairs
performed by the user, improper connection of the device or
incorrect operation.
To Next Page
Loading...
Need help?
General
