− Do not in any case push against the side of the saw blade to
stop it after switching off the motor.
− Observe the notes for lubricating and changing tools.
− All protective and safety devices must be immediately re-
mounted once repairs or maintenance are complete.
− Only use the transport fixtures to transport the machine; never
use the protective fixtures for handling or transport. The han-
dle openings for transport are located on both sides of the saw
housing.
− During transport, cover the top part of the saw blade, for ex-
ample, with the protective hood.
Safety notes for handling saw blades
− Keep your saw blades sharp and clean. Well maintained cut-
ting tools with sharp cutting edges are less likely to catch and
are easier to guide.
− Do not use deformed or cracked saw blades. It is not permissi-
ble to repair them. Worn, damaged or cracked saw blades may
increase the r
elease of dust.
− Do not use any saw blades that do not meet the characteristic
data specified in the instruction manual.
− These saw blades are not suitable for resharpening!
− Only use saw blades recommended by the manufacturer that
correspond to EN 847-1. When changing the saw blade, make
sure that the cutting width is not less and the thickness of the
steel blade is no greater than the thickness of the splitting
wedge.
− Only use saw blades whose maximum permissible speed is not
less than the maximum spindle speed of the table saw.
− Only saw blades that are suitable for the table saw (HM or CV
saw blades) may be used for the table saw. The use of HSS saw
blades and cutting discs of any kind is prohibited.
− Select a saw blade that is suitable for the material you intend
to cut.
To Next Page
Loading...
Need help?
General
