HANGZHOU WORLDE DIGITAL PIANO CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
parameter). Examples of these controllable parameters include volume, pan, expression, reverb, chorus and portamento.
Each of the controls on your Panda keyboard is able to send any of the 128 standard MIDI controller messages to control
such parameters. Please note that in order for these effects to work, the MIDI device you are sending to must be able to
receive these messages. A full list of these control messages is given in Appendix C.
For example, you may want to set the Modulation wheel to control the reverb amount. This is done by assigning
controller 91 to the Modulation wheel.
Examples of other popular effects are listed in the table below. (Please consult Appendix C for the full list.)
Effect Control
Modulation 1
Volume 7
Pan 10
Expression 11
Reverb depth
Chorus depth
There are many different types of virtual instruments available and most of these respond to MIDI controller messages,
allowing you to control a variety of parameters from your Panda keyboard. Please review the manual that came with
your software or external gear to see what these controller numbers are.
2.5.1 Programming the Controls on Your Panda
When programming a physical controller on your Panda, the controller that was last used will be the first one selected for
programming. To select a different physical controller for programming, the method is: Move the physical controller you
wish to program, and press the assignable button.
When in assign, the LCD displays the following:
2.5.2 ASSIGNABLE DIAL
There’re 8 dials that can be assigned channel and controller No. independently. First press the “Assign” button.
Then operate the dial to select the dial, and the LCD shows the controller number and the controller value.
Input the No. with NUMERIC button or +/- button when the dial is selected. The numbers are the controllers. you also
need to use the ‘Enter’ button to confirm the data.
For example: if you want to assign R1 to volume control 7, operation
steps is shown as below:
(1)Press the SHIFT button for one or two times until the LCD displays “Shift Off”.
(2)Press the “Ctrl Assign” button and the LCD displays “Assign”.
(3)Operate R1 knob.
(4)Press numeric button “7” and the LCD will display “7” on the bottom- left corner.
To Next Page
Loading...
