Worlde Panda - Section 3: Advanced Settings and Features; 3.1 Keyboard Performance Modes

HANGZHOU WORLDE DIGITAL PIANO CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
(4)Press “Shift” button and the LCD will display “Pad Note”.
(5)Press numeric button “3” and “4” and the LCD will display “34” on the bottom- left corner.
(6)Press the “Enter” button to confirm and the LCD will display “Done”.
2.5.8 Groups: A,B,C,D,E(49/61)
The button can be assigned as a controller. Press the ‘CTRL ASSIGN’ button, then press a button, the LCD
will display ‘ctrldata1’, input the number of the controller that you want to operate, press the 'enter' to confirm the value.
The LCD will display 'ctrldata2',at this moment, you can input the value that the controller should be send. For example: if
you want to assign A to control 18 which will send value 127, operation steps is shown as below:
(1)Press the SHIFT button for one or two times until the LCD displays “Shift Off”.
(2)Press the “Ctrl Assign” button and the LCD displays “Assign”.
(3)Press the “A” button and the LCD displays “ctrldata1”.
(4)Press numeric button “1” and “8” and the LCD will display “18” on the bottom- left corner.
(5)Press the “Enter” button to confirm and the LCD will display “ctrldata2”.
(6) Press numeric button “1”, “2” and “7” and the LCD will display “127” on the bottom- left corner.
(7)Press the “Enter” button to confirm and the LCD will display “Done”.
Section 3. Advanced Settings
3.1 How to make good use of the keyboard
3.1.1 DUAL
Dual switch function button.
When Dual is ON, the LCD displays the ‘DUAL_ON', Keyboard sends MIDI info of two channels, with the voice
/channel of both channels adjustable. The 2nd voice and channel of 2 layer can be adjusted currently (Dual is ON).
Dual and Split can not be used at the same time. When Dual is ON, Split is OFF. The operation steps and LCD displays
the following:
(1)Press the SHIFT button for one or two times until the LCD displays “Shift ON”.
(2)Press the “DUAL” button for one or two times until the LCD displays “Dual_ON”.
(3)Press the “Enter” button to confirm and the LCD will display “Done”.