HANGZHOU WORLDE DIGITAL PIANO CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
3.5.4
Select the Backlit RGB Color of 8 Pads
Press “SHIFT” button and the LCD displays “SHIFT ON”, the knobs R1, R2 and R3 are used for RGB color. R1 is
for red color. R2 is for blue color and R3 is for green color. Press the pad you want to change the RGB color and
then operate the knob R1,R2,R3 to change the RGB color of this pad. Press “SHIFT” button to exit the RGB color
setting mode. The operate steps are following:
(1) Press the “SHIFT” button for one or two times until the LCD displays “SHIFT ON”.
(2) Press one of the 8 PADs and the LCD displays “PAD”.
(3) Operate R1,R2,R3 to change the RGB color of the pad. During operation, the LCD displays the current RGB
color No. on the bottom-left corner. Maximum is 127, 0 means LED lights off.
(4) Press the “SHIFT” button to exit the RGB color setting mode.
(5) Reference RGB No. for some colors:
COLOR R. G. B
WHITE 127 127 127
BLACK 0 0 0
RED 127 0 0
GREEN 0 127 0
BLUE 0 0 127
CYAN 0 127 127
MAGENTA 127 0 127
YELLOW 127 127 0
ORANGE 127 82 0
3.6 MMC(MIDI MACHINE CONTROL)
There are 6 buttons used for MMC-[|<<],[<<],[>>],[O],[stop],[play].It is common to set the 6
buttons as Sequencer remote control buttons, it needs to be working with sequencer software.
3.7 NRPN/RPN setting
Assign the controller to 132~135, after that you can set the NRPN or RPN by numeric buttons.
Please consult Appendix D on Page 18 for full list.
To Next Page
Loading...
