Worx Jawsaw WG307E - Troubleshooting; Environmental Protection

Limbing and trimming electric chain saw EN
21
20
TROUBLESHOOTING
If your saw does not operate correctly check the following:
PROBLEMS POSSIBLE CAUSES POSSIBLE SOLUTION
• Tool will not start.
• Fuse blown or breaker
tripped.
• Extension cord notplugged
in.
• Check fuse or breaker.
• Check to make sure
extension cord is plugged
into a working outlet.
• Bar / chain overheated.
• Chain too tight.
• Lubrication needed.
• Refer to ADJUSTING THE
CHAIN TENSION section.
• Refer to LUBRICATION
section.
• Chain is loose. • Chain tension set incorrectly.
• Refer to ADJUSTING THE
CHAIN TENSION section.
• Poor cut quality.
• Chain tension set incorrectly.
• Chain needs replacement.
• Refer to ADJUSTING THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
• Refer to sections for
CHANGING THE GUIDE
BAR AND CHAIN.
• Unit runs but does not cut.
• Chain installed backwards.
See Fig H and illustration.
• Refer to CHANGING THE
GUIDE BAR AND CHAIN
section.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools and packaging
should be sorted, taken to the local recycling centre and disposed of in an environmentally
safe way.