Why is my Worx WG308 bar/chain overheated?
An overheated bar or chain on your Worx Chainsaw can occur due to a chain that is too tight or a need for lubrication. Please refer to the LUBRICATION section for details.
Defines the product's intended use and lists its components.
Instructions for adjusting and maintaining proper chain tension.
Steps for safely replacing the guide bar and saw chain.
Guidance on filling the oil tank and checking the automatic oiler.
Procedures for routine maintenance, cleaning, and proper storage.
Steps to prepare the JawSaw for use, including cord attachment and checks.
Instructions for starting, stopping, and performing various cutting tasks safely.
Guidance on assembling and using the extension pole for extended reach.
Defines the product's intended use and lists its components.
Instructions for adjusting and maintaining proper chain tension.
Steps for safely replacing the guide bar and saw chain.
Guidance on filling the oil tank and checking the automatic oiler.
Procedures for routine maintenance, cleaning, and proper storage.
Steps to prepare the JawSaw for use, including cord attachment and checks.
Instructions for starting, stopping, and performing various cutting tasks safely.
Guidance on assembling and using the extension pole for extended reach.
General| Type | Electric Chainsaw |
|---|---|
| Power Source | Corded Electric |
| Bar Length | 14 in |
| Voltage | 120V |
| Weight | 7.7 lbs |
| Chain Speed | 26.3 ft/s |
| Automatic Oiling | Yes |
| Oil Tank Capacity | 200 ml |
To Next Page
