Worx JawSaw WG320 - Troubleshooting

Cordless Limbing and Trimming Chain Saw EN
2322 2322
TROUBLESHOOTING
If your saw does not operate correctly check the following:
PROBLEMS POSSIBLE CAUSES POSSIBLE SOLUTION
•Toolwillnotstart. •Outofbattery. •Chargethebatterypack.
•Bar/chainoverheated.
•Chaintootight.
•Lubricationneeded.
•RefertoADJUSTING THE
CHAIN TENSION section.
•RefertoLUBRICATION
section.
•Chainisloose. •Chaintensionsetincorrectly.
•RefertoADJUSTING THE
CHAIN TENSION section.
•Poorcutquality.
•Chaintensionsetincorrectly.
•Chainneedsreplacement.
•RefertoADJUSTING THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
•Refertosectionsfor
CHANGING THE GUIDE
BAR AND CHAIN.
•Unitrunsbutdoesnotcut.
•Chaininstalledbackwards.
See Fig. H and illustration.
•RefertoCHANGING THE
GUIDE BAR AND CHAIN
section.