Worx Landroid WG795E - Mowing Area and Efficiency

Lawn Mowing Robot EN
11
If the Landroid
®
L senses that something is wrong, it will display a fault message on the Display (20), and will turn itself off
if it does not receive help within 20min to save energy (for information on fault messages refer to the Programming and
Troubleshooting Guide).
To turn back on:
s 0RESSITS!CCESS"UTTON
s /PENTHE+EYPAD7INDOW
s 0RESSITS/./&&+EYTO/.
s 0RESSBUTTON
s #LOSETHE+EYPAD7INDOW
s .OWTHE,ANDROID
®
L will begin to mow!
3.3 How big of an area can my Landroid
®
L mow?
Your Landroid
®
L is capable of mowing areas of up to around 1500m
2
, although this depends on various factors, such as:
s 3PECIESOFGRASSINYOURLAWNANDITSGROWTHRATE
s 3HARPNESSOFTHE"LADES
s (UMIDITY
s 3URROUNDINGTEMPERATURE
s !MOUNTOFOBSTACLESINYOUR,AWN
If the surrounding temperature is very cold where you live then your Landroid
®
L may charge at a slightly slower rate. The
Landroid
®
L uses less energy in open areas that have fewer obstacles, such as flower beds, fountains, walkways, etc…
See the chart below for mowing time suggestions depending on the area of your lawn.
Area(m
2
) Recommended time per day (hour)
200 1-2
500 2-3
1000 4-5
1500 5-6
Mowing times are different for every lawn depending on the factors mentioned previously. Gradually adjust the time you
allow your Landroid
®
L to mow each day until you find the most suitable setting.
If your neighbor also uses a Landroid
®
L, then you must keep a spacing of at least 3 metres between your Boundary Wire
and your neighbors.
Please be aware that your Landroid
®
L will not be able to receive a signal from the Boundary Wire
beyond the distance of 25m.
3.4 How efficiently will my Landroid
®
L mow the grass?
The Landroid
®
L’s cutting height can be adjusted between 2cm - 6cm. Before starting your Landroid
®
L for the first time, you
should cut the grass with a normal lawn mower. Then make sure you open the Grass Cutting Height Adjustment Cover (6)
and set the Landroid
®
L cutting height to its maximum cutting height of 6cm (See Fig. F, G).
G
20
25
30
35
40
45
50
55
60
F