To Next Page

To Previous Page

Lawn Mowing Robot EN

7.4 Winter hibernation

Your Landroid

M will live longer and healthier if it is allowed to hibernate. So even though it is tough, we would recommend

that you store your Landroid

M in your shed or garage during the winter.

Before you prepare your Landroid

M for winter hibernation, we recommend you:

• Thoroughly clean your Landroid

• Fully charge the battery

• Turn the power off

To maximize the battery life, it is recommended to fully charge the battery before storage during winter.

The Boundary Wire can be left in the ground although its ends should be protected, such as placed in a tin can with grease.

If the Charging Base is left outside for winter, leave the Boundary Wire connected.

NOTE: When bringing the Landroid

M back to work after winter hibernation, make sure the Charging Strips (5) and

Contact Pins (3) are clean, it is recommended to use a fine grade emery cloth to clean. Then make sure the date and time

are correct and send the Landroid

M back to what it loves doing: mowing.

7.5 Replacing the battery

WARNING: Press the ON/OFF Key to OFF before attempting any adjustment, replacement or repair.

If you need to replace the Battery, follow these steps:

1. Gently turn your Landroid

M upside down.

2. Remove the four screws on the battery cover (See Fig. N).

3. Take out the old battery (See Fig. O).

4. Put in the new battery.

5. Firmly replace the screws.

Environmental Protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.

Check with your Local Authority or retailer for recycling advice.

Worx Landroid Original Instructions

Other manuals for Worx Landroid