NOTE: When removing the battery pack, hold it
firmly to avoid potential accidents.
4. SAFETY ON/OFF SWITCH (See Fig. D)
The safety switch is locked off to prevent accidental
starting. Depress the lock off button (2) then depress
the on/off switch (3) and release lock off button. Your
trimmer is now on. To switch off, just release the on/off
switch.
WARNING! The cutting head continues to
rotate after the trimmer has been switched
off; wait until it has completely stopped then lay
down the tool.
OPERATION
WARNING: Always wear the eye protection.
Never lean over the trimmer head. Rocks or
debris can ricochet or be thrown into eyes and face and
cause blindness or other serious injury. When operating
unit, check for the following:
Wear eye protection and heavy clothing. Hold front
handle with one hand and auxiliary handle with the
other hand. Keep unit below waist level. Work only from
your right to your left to ensure debris is thrown away
from you. Without bending over, keep line near and
parallel to the ground (perpendicular when edging) and
not crowded into material being cut.
WARNING: Make sure that line is fed out
before operation. Make sure motor is up to
full speed before trimming.
WARNING: Use only 1.65mm diameter
cutting line. Other sizes of line will not feed
properly and will result in improper cutting head
function or can cause serious injury. Do not use other
material such as wire, string, rope, etc. Wire can break
off during cutting and become a dangerous projectile
that can cause serious injury.
FLOWER GUARD (See Fig. E)
Fold the Flower Guard (6) when edging and unfold it
before trimming, as shown in Fig. E Before trimming or
edging make sure the Flower Guard is locked firmly in
position.
TRIMMING (See Fig. E1)
Postion the trimmer head as shown in Fig. E1 for
trimming.
Keep the bottom of the trimmer head just above the
ground and at an angle. Allow only the tip of line to
To Next Page
Loading...
