Why Worx WR208E Lawn Mower secondary area is not mowed?
If the secondary area isn't being mowed by your Worx Lawn Mower, ensure the RFIDs are installed and reprogrammed correctly. Remove any obstacles between the RFIDs in the pathway. Also, make sure there is no boundary curved within 1.5 m range of the boundary wire for the RFID.
What to do if Worx Lawn Mower can't find the charging base?
If your Worx Lawn Mower can't find the charging base, ensure it docks right towards the base and departs in an anti-clockwise direction. Remove any obstacles within 2 meters in front of the charging base. Also, check that the QR code on the charging base is clear and unobstructed.
How to set the correct time on Worx Lawn Mower?
If your Worx Lawn Mower isn't operating at the correct time, ensure the clock is set correctly. Also, check and correct the programmed cutting times. If using the app, verify that the percentage of weekly operating time is set correctly.
Why Worx WR208E slips out of its working area?
If your Worx Lawn Mower slips out of its working area, check if the wheels are clean and free of mud to ensure maximum grip. If the slope is steeper than 30% (17 degrees), exclude the sloped area using a magnetic strip or a non-grass pathway. Remove any obstacles causing recognition errors, and ensure grass height is below 15 cm, using magnetic strips or a non-grass pathway near steps, cliffs, or ponds.
Why Worx WR208E charging time is too long?
If your Worx Lawn Mower is taking longer to charge, clean the contact pins on the charging pile and the charging strip on the mower with a cloth, as debris can cause poor connection. Also, the charging protection program might be activated due to high temperature; place the charging base in a shady area or wait until it cools down.
Why does my Worx Lawn Mower collide frequently?
Frequent collisions with your Worx Lawn Mower can happen if the grass is taller than 15 cm; trim it down. If there's grass around suspended objects like hanging fences or slides, lay magnetic strips or set up a 5 cm non-grass pathway around those areas.
How to fix the LED light on the Worx WR208E Lawn Mower charging pile when it doesn't turn on?
If the LED light on your Worx Lawn Mower's charging pile isn't turning on, the cause may be a lack of power. Ensure the charging base is correctly connected to the charger, and that the charger is properly connected to a functioning power supply.
What to do if Worx Lawn Mower software upgrade fails?
If the software upgrade fails on your Worx Lawn Mower, move closer to the router to strengthen the Wi-Fi signal. Also, ensure that the battery level is above 50% by placing the mower on the charging station.
Why Worx WR208E Lawn Mower cannot correctly dock with the charging pile?
If your Worx Lawn Mower isn't docking correctly, try restarting it, as environmental factors may be interfering. Also, clean the contact pins on the charging pile and the charging strip on the mower with a cloth to ensure good connection.
Why does my Worx WR208E Lawn Mower have shorter run-times?
Shorter run times for your Worx Lawn Mower can be caused by several factors. Check the blade disc for clogs and clean it, especially if the grass is high or thick. Examine the blade disc and blades for debris and replace them if necessary, as an unbalanced disc can increase power consumption. The battery might also be old and need replacement, or the working time may need to be reset.
General| Model | WR208E |
|---|---|
| Category | Lawn Mower |
| Power Source | Battery |
| Battery Type | Lithium-ion |
| Cutting Height Adjustment | Central |
| Warranty | 2 years |
To Next Page
