EasyManua.ls Logo

WSE Technologies DR4201 - Reader Operation (26-Bit and 34-Bit Wiegand Mode)

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DigiReader Series
12 P/N 6600025, REV. D
Key type 2 (HID ProxPro, ISOProx, DuoProx, and Corporate 1000):
For 120 msec the key message data is serially shifted into a buffer while searching for a
48-bit FSK-modulated Manchester-encoded signal. The received key data is valid if it
contains:
a start character with 2 Manchester code violations,
no other Manchester coding violations, and
the receive buffer contains two identical 48-bit key messages.
Reporting as an SNET DKR-type, only the key ID is reported to the ACU.
Reporting as an SNET MSR-type, this key is reported to the ACU in an SNET MSR-type
log response. The MSR data sent depends on the key type recognized:
26-bit key:
key data in message characters 7-10,
site code in message characters 11-14,
company code (always 9999) in message characters 19-22.
35-bit key:
key data in message characters 6-10,
site code in message characters 11-14,
company code (always 9999) in message characters 19-22.
37-bit key:
key data in message characters 6-10,
site code in message characters 11-14,
company code (always 9999) in message characters 19-22.
Only one keycode is received and reported at a time. A 1-second timer is started
when a key is read to prevent the same key from being repeated too quickly.
READER OPERATION (26-BIT AND 34-BIT WIEGAND MODE)
The RF field is powered at all times.
A digital key is received in the same fashion as for the SNET operation. (See above).
If the key is in 88-bit WSE format, then either the 32-bit (or 26-bit) keycode is immediately
transmitted via the data 0 and data 1 lines, most-significant-bit first.
If the key is a 48-bit type then the key content is checked to determine if 26-bit, 35-bit or
37-bit data is to be sent. If the content cannot be determined then no message is sent.
Only one keycode is received and reported at a time. A 1-second timer is started when a
key is read to prevent the same key from being repeated too quickly.
Проектирование. Монтаж. Продажа. - http://vskd.ru

Table of Contents