wsm wg972-e4 - Check Points of Every 1 Year

GENERAL
WG972-E4, WSM
G-24
[8] CHECK POINTS OF EVERY 1 YEAR
Replacing Air Cleaner Primary and Secondary Element
1. Remove the cover (2) from the air cleaner.
2. After cleaning the cover (2), remove the used air cleaner
primary (4) and secondary (3) element.
3. Replace the new air cleaner primary (4) and secondary (3)
element.
(When reassembling)
• Install the air cleaner cover with "TOP" indicated on the rear of
the cup.
IMPORTANT
• Make sure the hooking clip for cover for the element is tight
enough. If it is loose, dust and dirt may be sucked in,
wearing down the cylinder liner and piston ring earlier and
thereby resulting in poor power output
NOTE
• The air cleaner uses a dry element. Never apply oil to it.
• Do not operate the engine with filter element removed.
9Y1211108GEG0040US0
Replacing Gasoline Fuel Hose, Clamps and Fuel Filter
(Gasoline Line) [WG972-GL, WG972-G]
1. Replace the fuel filter (1) with a new one.
2. Replace the hose (2) and clamp (3) with new ones.
CAUTION
• In order to reduce the fuel pressure, do not remove the fuel
hose at least 3 minutes after stopping the engine.
• Remove the hose after covering the hose with a waste to
prevent scatter of fuel.
IMPORTANT
• When the fuel pipes are not installed, plug them at both
ends with clean cloth or paper to prevent dirt from entering.
Dirt in the pipes can cause fuel injector malfunction.
9Y1211108GEG0041US0
Cleaning Fuel Tank Inside (Gasoline Line) [WG972-GL,
WG972-G]
1. Following the unit / machine's operators manual, drain the
gasoline fuel in the fuel tank.
2. Clean the fuel tank inside.
9Y1211108GEG0042US0
(1) Air cleaner body
(2) Cover
(3) Secondary element
(4) Primary element
(5) Evacuator valve
(1) Fuel Filter
(2) Fuel Hose
(3) Clamp
KiSC issued 07, 2015 A