wtw Cond 3110 - Commissioning the Conductivity Meter; Scope of Delivery and Initial Setup; Battery Installation and Power On

Cond 3110 Commissioning
13
ba75792e02 11/2008
3 Commissioning
3.1 Scope of delivery
z Conductivity meter Cond 3110
z 4 batteries 1.5 V Mignon type AA
z Short instructions
z CD-ROM with detailed operating manual
3.2 Initial commissioning
Perform the following activities:
z Insert the supplied batteries
z Switch on the meter.
3.2.1 Inserting the batteries
Note
Alternatively, you can also use Ni-MH rechargeable batteries (type
1 Unscrew the two screws (1) on the underside of the meter.
2 Open the battery compartment (2) on the underside of the
meter.
3 Place four batteries (type Mignon AA) in the battery
compartment.
2
1