Cond 3110 Operation
17
ba75792e02 11/2008
4.2.1 Measuring the conductivity
4.2.2 Measuring the salinity
1 Perform the preparatory activities according to section 4.2.
2 Immerse the conductivity measuring cell in the test sample.
3 If necessary, scroll with <M> until the measured parameter
with the unit mS/cm or µS/cm is displayed.
4 Wait for a stable measured value.
The AR display indicator flashes as long as the measured
value is not yet stable.
1 Perform the preparatory activities according to section 4.2.
2 Immerse the conductivity measuring cell in the test sample.
3 Using <M>, scroll as necessary until the measured parameter
Sal is displayed.
4 Wait for a stable measured value.
The AR display indicator flashes as long as the measured
value is not yet stable.
To Next Page
