Need help?Do you have a question about the wtw Cond 3210 and is the answer not in the manual?
General| Temperature accuracy | ±0.1 °C |
|---|---|
| Memory | 500 data sets |
| Protection class | IP 67 |
| Weight | 400 g |
| Conductivity accuracy | ±0.5 % of value |
| Salinity range | 0.0 to 70.0 |
| TDS range | 0 ... 1999 mg/l |
| Reference temperature | 20 °C or 25 °C |
| Interface | RS232 |
| Power supply | 4 x AA batteries |
| Resolution | 0.01 µS/cm |
| Temperature Compensation | nLF, linear |
| Operating Conditions | 0 to 95% RH |
| Storage Conditions | 0 to 95% RH |
| Temperature range | -5.0 ... +105.0 °C |
Detailed explanation of each key on the conductivity meter and their functions.
Explanation of the display segments, measured values, and status indicators.
Specifies the approved measurements and environments for the meter.
General safety guidelines and warnings for operating the meter.
Ensuring safe operation and defining user responsibilities.
Steps for immersing the cell, selecting variables, and freezing values.
Settings for calibration record, interval, cell constant, reference temp, etc.
Procedure for determining and calibrating the cell constant.
Restoring conductivity measurement parameters to default values.
Solutions for when the measured value is outside the measuring range.
Solutions for contaminated measuring cells or unsuitable calibration solutions.
Procedure for resetting the meter when keys do not respond.
To Next Page
