wtw Cond 3210 - Conductivity Cell Settings and Calibration

Cond 3210 Operation
31
ba75794e04 04/2012
4.4.4 Settings for conductivity measuring cells
Overview The following settings are possible for conductivity measuring cells:
 Calibration record (display)
 Calibration interval
 Measuring cell/cell constant
 Reference temperature
 Temperature compensation
 TDS factor
 Unit of the temperature
 Automatic Stability control
Settings The settings are made in the measuring menu of the conductivity
measurement. To open the settings, activate the relevant measuring
window in the measured value display and press the <F1>/[menu] or
<ENTER> key shortly. After completing the settings, switch to the
measured value display with <M>.
Menu item Possible
setting
Description
Calibration /
Calibration record
- Displays the calibration
record of the last calibration.
Calibration /
Calibration interval
1 ... 999 d Calibration interval for the
measuring cell (in days).
The meter reminds you to
calibrate regularly by the
flashing sensor symbol in
the measuring window.