wtw pH 7110 - Resetting the measurement and system settings

pH 7110 Reset
ba75925e01 07/2011 35
Measurement and system settings that can be reset
The following settings are reset to the delivery condition (default):
• Measurement settings
• System settings
• Calibration data
Recalibrate after performing a reset.
Measurement settings Default
Display during calibration (bUFF ) pH (nominal buffer value)
Unit of the value for the slope (SLO )mV/pH
Unit of the value for the zero point
(ASY )
mV
Measured value resolution (pH rES) 0.000
Measured value resolution (U rES)0.0
Unit of the measured temperature
value (Unit )
°C
Calibration interval (Int.C )7 d
System settings Default
Switch-off interval (t.Off )1 h