ADVANCED OPERATION
1
2
4
the CONNECT button. You will notice the button change
toshow ‘disconnect’ and CONNECT STATE change
to green for ‘connected’. Pressing the button again will
disconnect the Com port and the CONNECT state will
show red.
Input/Output Switch - Switches connected inputs
per output.
Operation as with remote control handset – select the
chosen input to be displayed on each output by either
clicking the left/right arrow buttons to scroll through inputs
numerically, or pressing the input number 1-4.
iv. LAN Control with SmartSet Gui
The matrix can also be controlled via LAN over a network/
web browser using the supplied WyreStorm software
or LAN protocols from third party companies, such as
Control 4.
Attention Use a ‘straight through’ ethernet cable
for switch/router connection and a ‘cross-over’
cable for connection to a PC. Using the incorrect
cable will not damage your equipment, but it may
result in poor/no connection. Make sure that
your LAN cable is correctly terminated and firmly
connected to ports before running the software
Unzip the file WS IP Device Scanner ( NEW LAN
BOARD) and double click on the SmartSetGui application
Initially the document is in Chinese. To change this,
click on the characters on the top of the tool bar with a (L)
next to it, and select English from the menu options.
You may have to exit and re-enter the application for the
change to take effect.
If you do not initially see your matrix being
connected, click on the SEARCH button
a. If it is recognized, it may show up as the default Matrix
8:8 setting rather than MX-0404-POH-KIT
Select the matrix and click on SET-UP. From here
you can change settings on the network card
- Network: Enable DHCP to set a static IP, etc.
Sockets: Drivers are built around the use of Port 23. If
you see that the Port is set to 1984, change to Port 23
9
3
To Next Page
Loading...
