PANEL DESCRIPTIONS - RECEIVER
Rear
RS232 Port - Matrix only
LAN port
EDID DIP Switch (for manual EDID setting)
24V DC power input
IR Extension port (IR EXT)
UTP Output ports 1-4 (RJ45 Cat5e/6)
IR TX Emitter ports (corresponds to inputs)
Input ports (HDMI)
IR RX Receiver ports (corresponds to outputs)
1
5
4
8
9
2
6
3
7
1 5
9
4 82 6 63
7
6ii. Panel Description - Receiver
Front
1
4
5
2
3
Receiver Mode Normal: unit operation and RS232 control
Update: RS232 rmware update mode used to update the rmware of
the receiver
Note: When used with the MX-0404-POH-KIT the RS232 port can only be used for
rmware update – serial control of the receiver itself is not possible
Power LED On: Receiver powered (either by PoH or mains)
O: Receiver not powered (no power supply detected)
Status LED Slow Flashing: Receiver functioning correctly
O: Receiver not functioning correctly – investigation and
troubleshooting recommended
HDCP LED On: HDCP video being transmitted
Rapid Flashing: Non-HDCP video being transmitted
Link LED On: Receiver and matrix linked and transmitting correctly
O/Blinking: Connection issues exist between receiver and matrix –
investigation and troubleshooting recommended
1 54
2
3
To Next Page
Loading...
