Copyright © 2015 WyreStorm Technologies | wyrestorm.com
Audio/Video Connections
The following steps provide for connection of sources and displays to the switcher for basic operation. After completing these steps,
sources can be selected using the front panel buttons. For advanced control using the Web UI, I/O switching devices, or RS-232, see
Control and LAN Connections.
IMPORTANT!
Do not connect or disconnect (hot plug) the HDMI or HDBaseT connections while the switcher is powered on. Doing so may cause
damage to the switcher or connected devices.
1. Install the SW-0501-HDBT on a solid flat surface such as a cabinet or rack shelf located in a dry, well ventilated area.
2. Connect the sources to the switcher:
Note:
While not shown, sources may be routed through desk plates located on table or in podiums.
Connect HDMI sources to HDMI In 1-4 using an HDMI cable from a high quality brand such as WyreStorm Express.
(Optional) Connect the VGA Out from a VGA source to the VGA In. Connect the audio out for the VGA source to the Audio In
using a cable terminated per the Audio In Wiring section.
(Optional) Connect a microphone to the Mic In using a cable terminated per the Microphone Wiring section.
IMPORTANT!
Verify that Phantom Power switch on the rear panel is set to Off before connecting dynamic (passive) microphones.
o If using a microphone requiring 48V DC to power On, ensure that the Phantom Power switch on the rear panel is set to On
position.
o The gain for the microphone can be adjusted using the Mic Gain knob located on the front panel of the switcher.
3. (Optional) Connect the Audio Out on the switcher to an input of an Audio Amplifier using a cable terminated per the Audio In Wiring
section.
4. Connect the HDMI Out to a local display device such as a projector or HDTV.
5. Connect the HDBaseT Out on the switcher using a cable terminated per the HDBaseT Wiring section.
6. Connect the opposite end of the HDBaseT cable to a WyreStorm HDBaseT receiver, switcher, or 3rd party display device with built-
in HDBaseT receiver.
To Next Page
Loading...
