Wyrestorm SW-0501-HDBT - Rear Panel

6 of 22
SW-0501-HDBT HDBaseT Presentation Switcher/Scaler Installation Guide | 160211-1512
Rear Panel
AC Power
Connect to a 100~240V AC 50/60Hz AC mains outlet.
Phantom Power
On: Provides 48V DC 100mA to a microphone connected to Mic In
Off: No power supplied – Use this setting for dynamic (passive) microphones.
Mic In
3-pin Screw Down Phoenix Connector
Connect to a microphone to allow for combining with selected source audio.
IMPORTANT!
Verify that Phantom Power switch on the rear panel is set to Off before connecting dynamic (passive)
microphones.
Audio In
3-pin Screw Down Phoenix Connector
Connect to the analog audio output of the VGA source connected to the VGA In. Audio signal received on
this port is played only when the VGA input is selected.
Audio Out
3-pin Screw Down Phoenix Connector
Connect to the line level input of an audio pre-amplifier or powered speaker for audio output from selected
sources.
Contact In/
LED Out
11-pin Screw Down Phoenix Connector
Connect to a remote I/O control device such as a panel switch for selecting inputs remotely.
RS-232 1-2
4-pin Screw Down Phoenix Connector
RS-232 1 is used for controlling the SW-0501-HDBT via an external control system.
RS-232 2 is used for controlling local devices such as connected sources.
Refer to RS-232 Wiring for more details.
IR
5-pin Screw Down Phoenix Connector
Used to send and receive IR signals to/from the remote display location via HDBaseT.
RS-232
3-pin Screw Down Phoenix Connector
Used to send RS-232 signals to/from devices connected to an HDBaseT receiver via the HDBaseT Out port.
Refer to RS-232 Wiring for more details.
Reset
Press and hold for 5 seconds while the SW-0501-HDBT is powered on to restore factory default settings.
HDMI In 1-4
19-pin type A HDMI female digital video/audio input.
Supports HDMI and DVI/D (requires adapter-not included).
VGA In
15-pin VGA VESA (DSUB 15)
Connect to DSUB 15 VGA output of device such as a computer
15-pin VGA cable is required.
HDMI Out
19-pin type A HDMI female digital video/audio input.
Supports HDMI and DVI/D (requires adapter-not included).
HDBaseT Out
8-pin RJ-45 female
Connect to an HDBaseT receiver.
LAN
8-pin RJ-45 female | 10/100 Mbps auto-negotiating
Connect to a network router or switch for accessing the Web UI or IP Control.