What to do if my Xantrex Battery Charger shows an inverter overload shutdown?
If the Xantrex Battery Charger experiences an inverter overload shutdown, reduce the AC load and manually restart the system.
What to do if my Xantrex Battery Charger shows a backfeed shutdown error?
If the Xantrex Battery Charger experiences a backfeed shutdown due to incorrect AC wiring, correct the AC wiring before use and then manually restart the system.
Why does my Xantrex Battery Charger show a battery voltage warning?
If the Xantrex Battery Charger is inverting, charger is ready but no external AC is available, and you receive a battery voltage warning (10V15V), this is a warning. It indicates that the battery voltage is less than 10 volts or more than 15 volts.
How to reset Xantrex Freedom 458 Battery Charger when inverter is off but charging?
To reset the Xantrex Battery Charger when the inverter is OFF but charging, push the INVERT button. The LED should blink to indicate a reset.
Why is my Xantrex Freedom 458 Battery Charger inverting but no external AC is available?
When the Xantrex Battery Charger is inverting, charger is ready but no external AC is available, this is normal.
Why is my Xantrex Freedom 458 Battery Charger inverter in standby while charging?
When the Xantrex Battery Charger inverter is in standby and the battery is being charged, this is normal. The charging current is limited if the AC load exceeds the Power Sharing setting.
General| Frequency | 50/60 Hz |
|---|---|
| Efficiency | >85% |
| Output Voltage | 12V |
| Input Voltage | 120V AC |
| Battery Type | Gel, AGM |
| Protection Features | Overload, Short Circuit |
Conditions or practices that could result in injury, loss of life or damage.
Legal statement regarding copyright ownership and rights.
Legal statement limiting liability for product use.
Details on the unit's internal and external circuit breakers for safety.
Energy saving feature that reduces battery consumption when no AC load is present.
Automatic shutdown based on battery voltage levels to protect the unit.
Feature to automatically reduce charger output to allow AC power to the load.
Adjusts charge voltage based on battery temperature for optimal charging.
Description of the unit's buttons and LEDs for operation and status.
How to turn the inverter on/off and reset after a fault condition.
How to turn the charger on/off and select battery types.
Procedure to select the battery type using the Charge switch.
Interpreting the meaning of the LED indicators during operation.
Indicates battery voltage warnings or shutdown conditions.
Indicates over-temperature or overload conditions.
Description of the optional remote panel for monitoring and control.
Features of the LINK 2000 unit for battery bank monitoring.
Overview of advanced remote control options available.
Capabilities of the LINK 1000 for battery monitoring and control.
Additional features of the LINK 2000-R, including alternator regulation.
Overview of recommended deep-cycle battery types: wet cell, gel cell, AGM.
Design and features of Xantrex chargers for optimal battery charging.
List of common tools required for the installation process.
List of necessary accessories for a proper installation.
Important considerations and guidelines for mounting and positioning the unit.
Requirements for connecting AC power sources to the inverter/charger.
Instructions for connecting AC output wires to loads or distribution panels.
Details on what is covered under the limited warranty.
Xantrex's commitment to repair or replace defective products.
Instructions on how to obtain troubleshooting or warranty service.
Examples of connecting to various shorepower sources.
Examples of different ways to connect the inverter/charger.
Recommendations for DC cable and fuse sizing.
To Next Page