What to do if Xantrex Freedom XC PRO 3000 Battery Charger AC output is overloaded?
If the Xantrex Battery Charger indicates an AC output overload shutdown, reduce the electrical loads connected to the unit's AC outlet. Also, inspect any connected appliances with high-surge ratings and disconnect them if necessary.
What to do if Xantrex Battery Charger shows over-temperature shutdown?
If the Xantrex Battery Charger displays an over-temperature shutdown, try the following: reduce the loads connected to the AC outlet, ensure that the ventilation grille is unblocked, and, if possible, move the unit to a cooler environment.
What to do if Xantrex Battery Charger gives AC output overload warning?
If the Xantrex Battery Charger is giving an AC output overload warning, reduce the loads connected to the AC outlet of the unit.
What to do if Xantrex Freedom XC PRO 3000 Battery Charger shows over-temperature alarm and fan lock alarm?
If the Xantrex Battery Charger is showing an over-temperature alarm and a fan lock alarm, take these steps: reduce the loads connected to the AC outlet, make sure the ventilation grille isn't blocked, move the unit to a cooler place if you can, and check the fan for anything that might be stopping it from spinning, removing any obstructions.
Why Xantrex Freedom XC PRO 3000 shows high battery voltage shutdown?
If the Xantrex Battery Charger is experiencing a high battery voltage shutdown (above 18.0 volts DC), check for external charging sources like a PV charger or an over voltage alternator, and disconnect them if needed.
What to do if Xantrex Battery Charger fan lock error occurs?
If the Xantrex Battery Charger displays a fan lock error, and there's nothing obviously wrong with the fan, try disconnecting the unit from both its DC and AC power sources, then reconnect and restart it. Perform Drip Shield Installation on page 47. If the error continues, contact customer service.
What to do if Xantrex Freedom XC PRO 3000 Battery Charger battery temperature is high?
Error detection and automatic charger temperature compensation are enabled only when the optional BTS (PN: 808- 0232-01) is installed. When the BTS is present and the error is detected, stop inverting (meaning, discharging the battery) and wait a minimum of one hour for the battery temperature to go down before resuming inverting.
What to do if Xantrex Battery Charger internal hardware error occurs?
If the Xantrex Battery Charger shows an internal hardware error that persists, contact customer service.
How to fix Xantrex Freedom XC PRO 3000 Battery Charger low battery voltage shutdown?
If a low battery voltage shutdown is imminent on your Xantrex Battery Charger, check the battery status and recharge if needed. Also, verify the DC cable sizing is correct and tighten any loose connections.
Details the components and functions of the Freedom XC PRO display panel.
Provides essential steps and considerations before starting the installation process.
Lists governing installation codes and standards applicable to the unit.
Lists the necessary tools and materials required for installing the Freedom XC PRO.
Outlines the main steps involved in the installation process.
Guides users through checks before contacting customer support for issues.
Lists warning messages, audible alarms, and error codes displayed on the LCD screen.
Provides a reference table for common problems, causes, and solutions.
General| Output Power | 3000 W |
|---|---|
| Input Voltage | 120 VAC |
| Output Frequency | 60 Hz |
| Surge Rating | 6000 W |
| Efficiency | 90% |
| Battery Type | Lithium-ion |
| Operating Temperature | -4°F to 122°F |
To Next Page