EasyManuals Logo

Xantrex Prosine PS2.5 User Manual

Xantrex Prosine PS2.5
117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Error Code Table
90 Prosine 2.5/3.0 Installation & Operation Guide
002 Battery Voltage is too low 1. Discharged battery.
2. Old or faulty battery.
3. Battery cables to the Pros-
ine inverter/charger are too
small, too long, or there is a
loose connection.
1. Charge battery.
2. Battery may not be hold-
ing charge properly. If
flooded, check electro-
lyte level and fill with dis-
tilled water if necessary.
Equalization may help if
recommended by the bat-
tery manufacturer. Battery
may be faulty and require
replacement.
3. Check cable size and
length against recom-
mendations in this man-
ual. Check and tighten all
connections. Large loads
may draw the voltage
down very quickly on a
small battery or in an
installation with cables
that are too small or too
long.
003 Battery Voltage is too high. 1. External charger or alterna-
tor has output voltage
greater than 16 V.
2. A 12V Prosine inverter/
charger could be connected
to a 24V battery (two batter-
ies in series).
1. Correct or disconnect the
external charging source.
2. Make sure the battery
bank is nominal 12V for a
12v Prosine.
006,065 Microprocessor communi-
cation error.
Remote display cable is
pinched or has loose connec-
tion.
Check display cable con-
nections and attempt
restart. If the problem per-
sists, try a replacement
cable.
If the problem persists, call
Xantrex.
Error
Code
Description of Fault Possible Cause Solution

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xantrex Prosine PS2.5 and is the answer not in the manual?

Xantrex Prosine PS2.5 Specifications

General IconGeneral
BrandXantrex
ModelProsine PS2.5
CategoryInverter
LanguageEnglish

Related product manuals