Easy Shunt™ Installation Instructions
975-0191-01-01 3
4. Attach all wires removed in step 1 back onto this new "load" shunt terminal.
5. Tighten the nuts to 8 – 9 Nm (6 – 7 ft-lbs) to secure these electrical connections.
6. Route the sensor cable to the charger and plug it into the Bank 1 connector on the
rear panel of the XC Series or BC Series Charger.
7. Connect the battery positive ring connector to the positive terminal of the battery, or
to another round post to stud battery terminal adapter if needed.
Using the Easy Shunt™ Sensor
In order to use the Easy Shunt™, AC power must be disconnected from the XC Series
or BC Series Charger. In addition, the Amp-Hours will only reset to zero and give an
accurate usage gauge if bank 1 has reached float (3 stage charging) or rest (2 stage
charging).
To display the Amp-Hours that have been used since Bank 1 was last fully
charged:
1. Ensure the charger is off and AC power has been disabled.
2. Press
ON/STANDBY.
The remote display will scroll the following information, in order, for bank 1.
• Highest priority charger fault or warning (if present)
• Highest priority battery fault or warning (if present)
• Battery voltage
• Amp-hours used (the Ah units indicator light on the remote display will
illuminate)
Round-headed
carriage bolt
To Next Page
Loading...
Need help?
General
