Xerox 8264E - Cleaning Menu (Setup Item 4 of 7 Total); Selection Menu (Setup Item 5 of 7 Total)

Handling the Printer
Xerox 8254E / 8264E Color Wide Format Printer
User Guide
4-50
Cleaning Menu (Setup item 4 of 7 total)
Allows you to set up parameters for performing head cleaning.
Access this menu by pressing the [Menu] key which causes "Menu1: Setup>" to appear in the control
panel’s display. Pressing the [-] key three times causes "Menu4: Cleaning>" to display. (The > character
after a menu name indicates that there are sub-menus under that menu.)
From the "Menu4: Cleaning>" display, press the [>] key. This takes you to the first sub-menu titled
"Clean1: Economy." Pressing the [-] and [+] keys allows you to increment up or down to each of the
Setup items in the left column below.
Note:
• Head cleaning can be performed when "Ready to Print" is displayed in the control panel.
Refer to the following for operation procedures. Cleaning the Head
Selection Menu (Setup item 5 of 7 total)
Allows you to set up the contents of the Setup menu. You can make invisible any setup items that you
do not normally use.
Access this menu by pressing the [Menu] key which causes "Menu1: Setup>" to appear in the control
panel’s display. Pressing the [-] key four times causes "Menu5: Selection>" to display. (The > character
after a menu name indicates that there are sub-menus under that menu.)
From the "Menu5: Selection>" display, press the [>] key. This takes you to the first sub-menu titled
"Select1: MediaType." Pressing the [-] and [+] keys allows you to increment up or down to each of the
Setup items in the left column below.
Setup Item Description
Economy Discharges a lesser amount of ink compared to Normal.
Normal Select this mode for normal cleaning.
Strong Discharges a greater amount of ink compared to Normal.
Used when the print head does not improve when Head cleaning is performed
at Normal setting.
LittleCharge Refills a small amount of ink.
Charges a small amount of ink when printing is not stable after ink
replenishment.
—
Pressing the [Enter] key causes "Cleaning **%" to be displayed in the control
panel and the Head cleaning to start.
The state of progress on the Head cleaning displays in % in the control panel.
Pressing the [Cancel] key shifts to the previous menu.