Supported Paper Sizes and Types
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide 183
• Store paper in dry conditions, away from extreme heat or cold, such as radiators or
open windows.
• Store paper flat on a shelf or pallet above floor level.
• Leave the paper wrapped and boxed until ready to be used.
• Re-wrap partly used packages of paper.
NOTE: Paper should not be stored in the paper trays.
Supported Paper Sizes and Types
This section lists the sizes and types of paper that can be used with the machine.
Supported Paper Sizes
The following table lists the paper sizes supported for each paper tray, duplex module
and the finisher.
NOTE: For the capacity of each tray, refer to the Specifications chapter.
Standard Sizes
NOTE: The standard sizes of paper that can be detected vary depending on the paper
size table specified by the Key Operator. For information on setting the paper size
table, refer to Paper Size Settings in the Setups chapter on page 198.
Paper Size
Dimensions
(mm)
LEF/SEF
Tray 1, 2/Tray 3, 4
(Two Tray Module)
Tray 3, 4
(TTM)
Tray 5
(Bypass)
Duplex
Module
Finisher
A6 105.0 148.0 LEF X X O X X
A5 148.0 210.0 SEF O X O O X
LEF X X O O X
A4 210.0 297.0 SEF O X O O O
LEF O OOOO
A3 297.0 420.0 SEF O X O O O
B6 128.5 182.0 SEF X X O O X
LEF X X O O X
B5 182.0 257.0 SEF O X O O X
LEF O OOOO
B4 257.0 364.0 SEF O X O O O
5.5 × 8.5” 139.7 215.9 SEF O X O O X
LEF X X O O X
7.25 × 10.5” 184.2 266.7 SEF X X O O X
LEF O OOOO
To Next Page
Loading...
Need help?
General
