Print Mode Settings
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide 219
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - NetWare
Allows you to change the input buffer memory capacity for NetWare interface within the
range of 64–1,024 KB in 32 KB increments using the scroll buttons. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Receiving Buffer - SMB Spool
Allows you to change the input buffer memory capacity for SMB interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 64–1,024 KB in 32 KB
increments using the scroll buttons.
Memory
Allows you to change the memory capacity within the range of 0.50–32.00 MB in 0.25
MB increments using the scroll buttons.
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - IPP Spool
Allows you to change the input buffer memory capacity for IPP interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 64–1,024 KB in 32 KB
increments using the scroll buttons.
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - Ethertalk
Allows you to change the input buffer memory capacity for Ethertalk interface within the
range of 1,024–2,048 KB in 32 KB increments using the scroll buttons. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
To Next Page
Loading...
Need help?
General
