Xerox DocuMate 4760 User Manual

Xerox
®
DocuMate
®
4760
User’s Guide
141
When Visioneer Acuity is installed, you can create multiple scan regions for each image scanned. The maximum
number of scan regions you can create when Visioneer Acuity is installed may vary between scanner models. When
creating scan regions and you reach the maximum number of allowable scan regions, you will not be able to
continue creating scan regions until you remove a region you have already created.
Move, Resize, or Delete Regions
Moving regions – to move a region, place your mouse cursor over the region you want to move. The region will
highlight indicating that it is the active region under the mouse cursor. Click on the region and drag the mouse to
move the region.
Resizing regions – to resize a region, place your mouse cursor over the edge of the region outline. The cursor will
change to a dual directional arrow. Click on the line and drag the mouse to resize the region. If you click on the top
or bottom edge, you can only resize the region up or down. If you click on the left or right edge, you can only resize
the region left or right. Click on a corner edge and then drag the mouse to resize the region in all directions.
Note that you can only resize the scan regions to be within the scanner’s minimum and maximum supported paper
sizes. Please refer to the scanner specification table, in the maintenance section of the user guide, for the supported
paper sizes for your scanner.

Xerox DocuMate 4760 Specifications

General

Brand	Xerox
Model	DocuMate 4760
Category	Scanner
Language	English