A.6 Installing the Internal Hard Disk 215
9. Re-attach the metal plate cover on the
printer by tightening the three screws
loosened in Step 4.
10. Re-attach the rear cover on the printer by
tightening the two screws removed in Step
2.
11. Plug in the power cord and switch the power on by pressing the power switch to the
<|> position.
The installation is now complete.
Note
• You can check whether the internal hard disk has been installed correctly by printing out the [Printer
Settings] list. Refer to "7.2 Printing the Reports/Lists" (P. 164) on how to print the [Printer Settings] list.
To Next Page
Loading...
Need help?
General