Configuring the PCL Drivers
Chapter 4: Printing
4-5
Paper/Output
Use this tab to change the number of copies, page orientation, paper
size, paper source and output format.
Source setting identifies the default paper source.
Manual Feed source is used when printing on special media, and
causes the printer to wait (up to 15 seconds) for you to press the
contol panel button before printing. Afterwards the printer will
attempt to print from whatever paper source is available, according
to the following priority: Manual Feed, then Tray 1.
Image Quality
Use this tab to change resolution and enhancement, graphic
settings, graphic mode, grayscale, and graphic quality. It also
includes settings that determine how the printer handles TrueType
fonts.
Overlays
Use this tab to create and use overlays. Please see the on-line help
in the PCL 6 driver.
Watermarks
Use this tab to create, modify and delete watermarks. You can
control the font size, font type and placement of watermarks. Please
refer to the on-line help in the PCL 6 driver.
About
This tab shows the software version and copyright information.
To Next Page
Loading...
Need help?
General