Xerox OLYMPIA ELECTRONIC COMPACT - TO CHANGE DEFAULTS

1. Setting of jumpers on header marked A thru H:
See illustration #2 (Option Setting)
a. Code
CR
LF
Jumper
11
A
11
Not Installed
Carriage Return + Line Feed
Ignored
Jumper
11
A
11
Installed
Express
Carriage Return + Line Feed
b. For Radio Shack Computers install a jumper on Position
11
C
11
•
This causes a CR+LF (Carriage Return + Line Feed) to occur
when either a CR (Carriage Return) or LF (Line Feed) is sent
from the host computer.
Note: Installing a jumper on
11
C
11
supersedes the setting of
the
11
A
11
jumper above.
c. For Parallel operation be sure that there is a jumper
installed on position
11
F
11
•
Note: Jumpers B-0-E-G and H are not used in parallel
operation.
2. Once you have made the proper connections above, it is time to
reposition the keyboard assembly.
Position the keyboard assembly and reinstall the two mounting
screws.
3. Replace upper housing and platen knob and reinstall the two
screws on the lower housing.
The 080 interface is now setup. Turn on the typewriter and
test it for proper operation from its keyboard. If it
performs properly, proceed with the hook up to the host
computer.
Attached is an ACSII Code Chart for the Olympia Electronic
Compact with 080 interface. Please note that the typewriter
keyboard has several characters which are not part of the
normal ASCII Code Set. These characters are printable by
using the substitute ASCII characters which are al·l listed in
the ASCII Code Chart.
- 5 -