Xerox Phaser 3635MFP/S - Set Measurements; Set Altitude

11 Setups
170 Xerox Phaser 3635MFP User Guide
Tools > Device Settings > General > GMT Offset
Set Measurements
The measurements that are displayed on the touch screen can be set to either
inches or mm. You can also set the decimal point (Numeric Separator) to
either a period (e.g. 12.3) or a comma (e.g. 12,3).
Tools > User Interface > General > Measurements
Set Altitude
The xerographic process used in your machine to make prints is affected by
air pressure. Air pressure is determined by the height of the machine above