Description of Menu Items
Phaser® 6125 Color Laser Printer
5-8
System Setup
System Setup menu is used to make the printer operation settings, such as for alarm and power
saver mode.
Host Access List Specifies blocking the reception of data from certain IP addresses.
Reset Defaults Initializes network data stored in NVM. The NVM is a nonvolatile memory that
stores the printer settings even after power off. Initializing the NVM will revert the
value for each item of the Wired Network menu to default.
Item Description
PowerSaver
Timer
Specify the transitional time to Power Saver between 5 and 60 minutes in
increments of 1 minute.
■ 5 min. to 60 min. (default: 30 min.)
■ For details, refer to Power Saver Mode on page 2-7
Audio Tone Specifies whether to turn on the alarm when an error occurs in the printer. You
cannot adjust the sound volume.
■ Control Panel (default: Off)
■ Invalid Key (default: Off)
■ Machine Ready (default: Off)
■ Job Complete (default: Off)
■ Fault Tone (default: Off)
■ Alert Tone (default: Off)
■ Out of Paper (default: Off)
■ Low Toner Alert (default: Off)
■ Base Tone (default: Off)
Time-Out You can cancel a printing process when it goes beyond a set time period. Set the
time until the print job is canceled. When this timeout expires, the print job is
canceled.
■ 5 sec. to 300 sec. (default: 30 sec.)
Specifies the amount of time in increments of 1 second the printer waits for
additional data before it cancels the job.
■ Off
Cannot cancel.
Panel Language Specifies the language that is displayed on the control panel and Information
pages.
Item Description
To Next Page
Loading...
