Printer Settings
Phaser® 7760 Color Laser Printer
4-11
Setting the Duration for the Tray 1 (MPT) Prompt
The Tray 1 (MPT) prompt setting specifies the amount of time the prompt displays on the
control panel after paper is loaded in the tray. The Tray 1 (MPT) prompt requests the user to
confirm the current tray setup or to specify the correct paper type and size for the print job.
To select a Tray 1 (MPT) prompt setting, use one of the following options:
■ The printer’s control panel
■ CentreWare IS
Using the Control Panel
To select the Tray 1 (MPT) prompt setting on the control panel:
1. Select
Printer Setup, and then press the OK button.
2. Select
Paper Handling Setup, and then press the OK button.
3. Select
Tray 1 (MPT) Prompt, and then press the OK button.
4. Select the appropriate duration, and then press the OK button.
Using CentreWare IS
To select the Tray 1 (MPT) prompt setting using CentreWare IS:
1. Launch your web browser.
2. Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select the General folder on the left sidebar, and then select Printer Defaults.
5. Select the appropriate setting in the Tray 1 (MPT) Prompt drop-down list.
6. Click the Save Changes button at the bottom of the page.
Duration Behavior
None (Factory default setting) Turns the tray setup prompt off.
30 Seconds Displays the tray setup prompt for 30 seconds after paper is
loaded in Tray 1 (MPT).
Infinite Displays the tray setup prompt after paper is loaded in
Tray 1 (MPT) until a control panel selection is made. The printer
will not print until a selection is made.
To Next Page
Loading...
Need help?
General