Printer Settings
Phaser® 7760 Color Laser Printer
4-17
Setting the Default Punch Option
If the printer has a finisher, the Punch Option setting specifies the default for punching output.
Print jobs use the default punch option unless a different option is selected in the printer driver
when a job is sent to the printer.
To select the default punch option, use one of the following options:
■ The printer’s control panel
■ CentreWare IS
Using the Control Panel
The factory default option for punching holes is Off. To select the default punch option on the
control panel:
1. Select
Printer Setup, and then press the OK button.
2. Select
Paper Handling Setup, and then press the OK button.
3. Scroll to
Punch, select either On or Off, and then press the OK button.
4. If your finisher has a 2- / 4-hole punch installed, select
2 Holes or 4 Holes, and then press
the OK button.
5. If your finisher has a 3-hole punch installed, select
3 Holes, and then press the OK button.
Using CentreWare IS
To select the default hole-punching option using CentreWare IS:
1. Launch your web browser.
2. Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Select General on the left sidebar, and then select Printer Defaults.
5. Select On from the Punch drop-down list to turn on hole punching. The default setting is
Off.
6. Select the appropriate hole-punching option from the Punch Holes drop-down list. The
default setting is 3.
7. Click the Save Changes button at the bottom of the page.
To Next Page
Loading...
Need help?
General