5. Touch Wi-Fi Protected Setup (WPS).
Note: If Wi-Fi Protected Setup (WPS) is not visible, at the top of the screen, touch Manual
Setup.
6. Touch PBC.
7. Touch OK.
8. On the wireless router, press the WPS button.
Note: If the wireless router does not have a physical PBC button, use your computer to
select the virtual button in the router control panel. For more information, refer to your
router documentation.
The router broadcasts setup information for 120 seconds.
9. To activate your Wi-Fi setting changes, restart the printer.
a. Press the Home button.
b. At the prompt, touch Restart Now.
10. After the printer restarts, wait two minutes, then to get the network information that includes the
IP address, print a Configuration Report. For more information, refer to Printing the Configuration
Report.
11. At the printer control panel, press the Home button.
12. If Wi-Fi is Off, turn it on.
a. Touch Device→Connectivity→Wi-Fi.
b. To toggle Wi-Fi from Off to On, touch the Wi-Fi toggle button.
c. To activate your Wi-Fi setting changes, press the Home button.
d. At the prompt, touch Restart Now.
Note: The following steps can vary with different router manufacturers. For more
information, refer to your router documentation.
13. At your computer, open the wireless router control panel, then select Add WPS Client.
14. Select PIN Method. The wireless router control panel opens to a dialog box ready for the PIN
number.
15. At the printer control panel, touch Device→Connectivity→Wi-Fi.
16. Touch Manual Setup.
17. Touch Wi-Fi Protected Setup (WPS).
Note: If Wi-Fi Protected Setup (WPS) is not visible, at the top of the screen, touch Manual
Setup.
18. Touch PIN.
19. Record the PIN from the screen, then touch OK.
Note: The printer continues to advertise for 120 seconds. If the printer does not locate the
wireless router within 120 seconds, the connection attempt stops.
The printer starts advertising using the displayed PIN Code.
Xerox
®
VersaLink
®
C600 Color Printer
User Guide
43
Getting Started