2. Grip the staple cartridge and pull it out of the stapler head.
3. Unpack the new staple cartridge. Remove any partial strips and any staple strips that are not flat.
4. Install the new staple cartridge in the stapler head. The staple cartridge clicks into place.
5. To close the stapler head, rotate the stapler head 180 degrees clockwise.
Emptying the Hole Punch Waste Container
When the hole punch waste container is full, a message appears on the control panel.
Emptying the Hole Punch Waste Container in the Office Finisher
Caution: Do not perform this procedure while the printer is printing.
207
To Next Page
Loading...
