Security
WorkCentre 7800 Series Multifunction Printer 75
System Administrator Guide
Configuring OCSP Validation Server Settings
If you have an OCSP server, or an OCSP certificate validation service, you can configure the printer to
validate certificates installed on the domain controller.
Before you begin:
Add a domain controller.
1. On the Login Methods page, next to Certificate Validation, click Edit.
2. Select a validation method and click Next.
3. On the Required Settings page, type the URL of the OCSP server.
4. To ensure that the printer can communicate with the OCSP server and the domain controller,
configure your proxy server settings as needed.
5. For each domain controller listed, under Domain Controller Certificate, select the corresponding
domain controller certificate from the menu. If there are no certificates installed, click Install
Missing Certificate.
6. Click Save.
Setting the Inactive Time Limit
1. On the Login Methods page, next to Smart Card Inactivity Timer, click Edit.
2. Specify the maximum amount of time before a user is logged out automatically. Type the time in
minutes.
3. Click Save.
Specifying the Method the Printer Uses to Acquire Email Address of Users
1. On the Login Methods page, next to Acquired Logged-in User's Email Address, click Edit.
2. Under Acquire logged-in user's email address from, select an option:
− Auto instructs the printer to attempt to acquire the email address of the user from the Smart
Card. If an email address is not associated with the Smart Card, the printer searches the
Network Address Book. If an email address is not found, the printer uses the email address
specified in the From Field. Edit From Field settings on the Required Settings tab of the Email
Setup page.
− Only Smart Card instructs the printer to acquire the email address of the user from the Smart
Card.
− Only Network Address Book (LDAP) instructs the printer to search the Network Address Book
to acquire the email address of the user.
3. To configure LDAP server settings, under Server Configuration, next to Network Address Book
(LDAP), click Edit.
4. To enable or disable Personalization, under Feature Enablement, next to Acquire Email from
Network Address Book, click Enable Personalization or Disable Personalization.
5. Click Save.
To Next Page
Loading...
Need help?
General
