Xerox WORKCENTRE 7425

11
Initial Settings Procedures Using
Control Panel
This chapter describes the initial settings related to Security Features, and how to set them on the machine’s
control panel.
Authentication for entering the System
Administration mode
1. Press the <Log In/Out> button on the control panel.
2. Enter "admin" with the keyboard displayed. This is the factory default "ID".
3. Select [Next] on the touch screen.
4. Enter "1111" for passcode from the keyboard.
5. Select [Enter] on the touch screen.
6. Select [Tools].
Change the System Administrator’s Passcode
1. Select [Authentication/Security Settings] on the [Tools] screen.
2. Select [System Administrator Settings].
3. Select [System Administrator’s Passcode].
4. On the [System Administrator's Passcode] screen, Select [Keyboard].
5. Enter a new passcode of 9 or more characters in [New Passcode], and select [Save].
6. In [Retype Passcode], select [Keyboard].
7. Enter the same passcode, and select [Save] twice.
8. In the [Do you want to change the System Administrator’s Passcode?] screen, select [Yes].
Set Maximum Login Attempts
1. Select [Authentication/Security Settings] on the [Tools] screen.
2. Select [Authentication].
3. Select [Maximum Login Attempts By System Administrator].
4. On the [Maximum Login Attempts] screen, select [Limit Attempts].
5. With [ ] and [ ], set [5].
6. Select [Save].