Xerox WorkCentre 7556 User Manual

Troubleshooting
212 WorkCentre 7500 Series Multifunction Printer
User Guide
8. If the original is not visible when the document cover is opened, lift up the document feeder tray,
then remove the paper.
9. Lower the document feeder tray.
10. If the original is not wrinkled or torn, load it into the feeder again following the instructions on the
touch screen.
Note: After clearing a document feeder jam, reload the entire document, including the pages already
scanned. The printer automatically skips the scanned pages and scans the remaining pages.
CAUTION: Torn, wrinkled, or folded originals can cause jams and damage the printer. To copy torn,
wrinkled, or folded originals, use the document glass.
Clearing Jams in the Integrated Finisher
1. Locate the Integrated Finisher mounted beneath the Scanner and Control Panel.
2. Open the top cover of the finisher (1).
3. Turn the green knob in the direction shown to remove the paper (2).
4. Remove the paper by pulling it in the direction shown.
Note: If the paper is torn, remove all torn pieces from the printer.
2
1
5. Close the top cover of the Integrated Finisher.

Xerox WorkCentre 7556 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed (Black)	55 ppm
Print Resolution	1200 x 2400 dpi
Copy Speed (Black)	55 ppm
Copy Resolution	600 x 600 dpi
Maximum Paper Capacity	5, 140 sheets
Monthly Duty Cycle	Up to 300, 000 pages
Processor	1.2 GHz
Memory (Standard)	2 GB
Hard Drive	160 GB
Copy Speed (Color)	50 ppm
Scan Resolution	Up to 600 x 600 dpi
Paper Sizes	A3, A4, A5, B4, B5
Connectivity	10/100/1000Base-T Ethernet, USB 2.0
PDL	PCL 5c, PCL 6, PDF
Mobile Printing	Apple AirPrint, Xerox Mobile Print
Print Speed (Color)	50 ppm
Duplex Printing	Automatic