107
7. Click the Device Access [Configure] or [Edit] button.
8. From the drop-down menus for each item, select the method to use to display that item to users.
9. Click [Save] when done.
10. Click the Service Access [Configure] or [Edit] button.
11. From the drop-down menus for each item, select the method to use to display that item to users.
12. Click [Save] when done.
13. Click [Finished] on the Authentication Configuration screen when finished.
14. Select [Logout] in the upper right corner of your screen if you are still logged in as Administrator.
To Next Page
Loading...
