13
To Change the Ethernet Speed, if needed
1. Go to a networked workstation, open a Web browser application, enter the TCP/IP address of the
machine in the Address bar, and press Enter.
2. Select the [Properties] tab.
3. Enter the Administrator User name and password if prompted. The default is [admin] and [1111]
4. Select [Connectivity].
5. Select [Physical Connections].
6. Select [Ethernet].
7. Select your [Rated Speed].
8. Click [Apply].
9. When you see the window that says that the properties have been successfully modified, select the
[Status] tab, and click [Reboot Machine].
10. When the machine has re-booted, verify the Ethernet speed setting displayed under Ethernet Profile
on the machine's Configuration Report, which is set to print, by default, whenever the device is
powered on.
11. To print a Configuration Report on demand, go to the machine and press the [Machine Status] button.
Next, touch [Print Reports], then touch [Configuration Report], then touch [Print Selected Report], and
finally touch [Close].
To Next Page
Loading...
Need help?
General
